HomeIndustries Use Cases PricingResources Book a TourLog In to MaintainXIndustries Use Cases PricingResources Book a TourLog In to MaintainX Back General • MaintenanceGenerac Diesel Generators MMG75: Annual Maintenance (John Deer Engine)MaintainX10/24/2021Generac Diesel Generators MMG75: Annual Maintenance (John Deer Engine)JACK MAINTENANCEThe following procedures should be performed at least annually. SIDE-WIND MODELSThe internal gearing and bushings of the jack must be kept lubricated. Apply a small amount of automotive grease to the internal gearing by removing the jack cover, or if equipped, use a needle nose applicator or standard grease gun on the lubrication point found on the side of the jack near the crank. Rotate the jack handle to distribute the grease evenlyA lightweight oil must be applied to the handle unit at both sides of the tube.If equipped, the axle bolt and nut assembly of the caster wheel must also be lubricated with the same lightweight oil.TOP-WIND MODELSScreenshot2021-04-24at11.57.48AM.pngApply a lightweight oil to the screw stem.Source: Generac
Back General • MaintenanceGenerac Diesel Generators MMG75: Annual Maintenance (John Deer Engine)MaintainX10/24/2021Generac Diesel Generators MMG75: Annual Maintenance (John Deer Engine)JACK MAINTENANCEThe following procedures should be performed at least annually. SIDE-WIND MODELSThe internal gearing and bushings of the jack must be kept lubricated. Apply a small amount of automotive grease to the internal gearing by removing the jack cover, or if equipped, use a needle nose applicator or standard grease gun on the lubrication point found on the side of the jack near the crank. Rotate the jack handle to distribute the grease evenlyA lightweight oil must be applied to the handle unit at both sides of the tube.If equipped, the axle bolt and nut assembly of the caster wheel must also be lubricated with the same lightweight oil.TOP-WIND MODELSScreenshot2021-04-24at11.57.48AM.pngApply a lightweight oil to the screw stem.Source: Generac
