Back
Manufacturing / Industrial • Maintenance

2013 ELECTRIC HYSTER J40XNT ELECTRIC 3 WHEEL SIT DOWN 500 Hours /3 Months

The 2013 ELECTRIC HYSTER J40XNT ELECTRIC 3 WHEEL SIT DOWN 500 Hours /3 Months is a form that focuses on the drive tire and wire assemblies. The instructions are divided into several categories based on the equipment's parts which you can inspect through a checklist.
MaintainX
04/26/2021

2013 ELECTRIC HYSTER J40XNT ELECTRIC 3 WHEEL SIT DOWN 500 Hours /3 Months

The 2013 ELECTRIC HYSTER J40XNT ELECTRIC 3 WHEEL SIT DOWN 500 Hours /3 Months is a form that focuses on the drive tire and wire assemblies. The instructions are divided into several categories based on the equipment's parts which you can inspect through a checklist.

    Drive Tire and Wheel Assemblies

    Pedals, Seat Assembly, Hood, Hinges, and Hood Latch

    Use Multipurpose Grease

    Inspect for:

    Breather Cap

    Figure 3. Motor Locations, Lift Trucks Manufactured

    • 30.PNG

    Manual Override Handle

    Use Multipurpose Grease.

    Figure 22. Automatic Parking Brake Override Handle

    • 32.PNG

    Silicone Spray Lubricant. Hyster P/N 328388.

    Master Cylinder Reservoir

    Visually check the :

    Use Multipurpose Grease.

    Mast Mounting Caps crews

    Inspection of Mast, Carriage, Header Hoses, Lift Chains, and Attachments

    Figure 32. Mast Lubrication

    NOTE: MAST IS DIFFERENT, BUT LUBRICATION AREAS ARE THE SAME.

    Lift Chains

    Visually inspect hoses/fittings for

    hydraulic leaks

    hose covers for cuts

    cracks

    exposed reinforcement

    defective/broken clamping devices or sheaves

    proper tracking during operation

    NOTE: Chain anchor pins MUST be replaced any time chains are replaced.

    Figure 33. Check the Lift Chains

    Adjustments or replacement of the lift chains must be done by authorized personnel.

    Header Hoses, Hose Fittings, and Clamps

    Inspect for :

    Fork Guides and Pins

    WARNING: DO NOT try to move a fork without a lifting device. The forks can weigh 45 to 115 kg (99 to 254 lb).

    Figure 31. Fork Lock Pin Assembly

    Transaxle

    Direction and Speed Control Pedals (Use Silicone Spray Lubri- cant. Hyster P/N 328388)

Source: Hyster

Please note that any procedure, checklist, or other document available in the MaintainX Procedure Hub is provided for general education and information only and does not constitute legal, medical, or financial advice. MaintainX makes the materials available AS IS and AS PROVIDED, without warranties of any kind. By downloading or using any such materials, you assume the risk that they may not be appropriate for your specific situation and agree that you are solely responsible for any such use, including compliance with applicable law and with meeting any conditions of product warranties.