Wendy's Henny Penny Computron 2000 Pressure Fryer/500,600: As Required Maintenance

The following steps will help prevent filter pump problems:

• Make certain the charcoal filter is installed with the smooth side down and the arms on the frame are clamped down over the protrusions on the outside of the frame.

• The filter valve is to be closed at all times during frying.

• Pump all the shortening from the filter lines by running the filter pump motor until the shortening in the frypot appears to be bubbling or boiling.

Changing the Filter Envelope

• Move the main power switch to the OFF position

• Remove and empty the condensation drain pan

• Disconnect the filter union and remove the drain pan from under the frypot. If available, a drain pan may have casters under it, allowing easy transport of filter pan and filter assembly

• Lift the screen assembly from the drain pan

• Wipe the shortening and crumbs from the drain pan. Clean the drain pan with soap and water, then thoroughly rinse with hot water.

• Unthread the suction standpipe from the screen assembly

• Remove the crumb catcher and clean thoroughly with soap and water then Rinse thoroughly with hot water

• Remove the filter clips and discard the filter envelope

• Clean the top and bottom filter screen with soap and water then rinse thoroughly with hot water

• Be sure that the filter screens, crumb catcher, filter clips, and the suction standpipe are thoroughly dry before assembly of filter envelope as water will dissolve the filter paper

• Assemble the top filter screen to the bottom filter screen

• Slide the screens into a clean filter envelope

• Fold the corners in and then double fold the open end

• Clamp the envelope in place with the two filter retaining clips

• Replace the crumb catcher screen on top of the filter paper. Screw on the suction standpipe assembly

• Place complete filter screen assembly back into filter drain pan and slide pan back into place beneath the fryer

• Connect the filter union by hand. Do not use a wrench to tighten

• Slide the condensation drain pan back into place. The fryer is now ready to operate