Daikin Vision Semi-Custom Indoor Air Handler (Vision CAC/CAH): Every 2000 Hours Maintenance
This procedure if for your equipment's supply and return fans—Supply and return fan motors should have grease added after every 2000 hours of operation. This will help maintain your equipment's stability and high performance.
MaintainX
10/24/2021
Daikin Vision Semi-Custom Indoor Air Handler (Vision CAC/CAH): Every 2000 Hours Maintenance
This procedure if for your equipment's supply and return fans—Supply and return fan motors should have grease added after every 2000 hours of operation. This will help maintain your equipment's stability and high performance.
Ball Bearing Lubrication
CAUTION!
Bearing overheating potential. Can damage the equipment. Do not over lubricate bearings. Use only a high grade mineral grease with a 200°F safe operating temperature. See below for specific recommended lubricants.
Motor Bearings
Supply and return fans—Supply and return fan motors should have grease added after every 2000 hours of operation. Using the following procedure, re-lubricate the bearings while the motor is warm, but not running.
Use one of the greases shown in Table 35.
Fan Shaft Bearings
Any good quality lithium or lithium complex base grease, using mineral oil, conforming to NLGI grade 2 consistency, and an oil viscosity of 455-1135 SUS at 100°F (100-200 cSt at 40°C) may be used for re-lubrication.
Compatibility of grease is critical. Lubricatable bearings are supplied with grease fittings or zerks for ease of lubrication with hand or automatic grease guns. Always wipe the fitting and grease nozzle clean.
Source: Daikin (oslo.daikinapplied.com)