General • Maintenance

Odyssey® Split Systems with Symbio Controls: Monthly Maintenance

This procedure is the recommended monthly maintenance procedure for your equipment. Performing all maintenance procedures and inspection at the recommended intervals will prolong the life of your chiller and minimize the possibility of malfunctions.

MaintainX

10/24/2021

Odyssey® Split Systems with Symbio Controls: Monthly Maintenance

Maintenance

! WARNING

Hazardous Voltage w/Capacitors!

Failure to disconnect power and discharge capacitors before servicing could result in death or serious injury.

Disconnect all electric power, including remote disconnects and discharge all motor start/run capacitors before servicing. Follow proper lockout/tagout procedures to ensure the power cannot be inadvertently energized. For variable frequency drives or other energy storing components provided by Trane or others, refer to the appropriate manufacturer’s literature for allowable waiting periods for discharge of capacitors. Verify with a CAT III or IV voltmeter rated per NFPA 70E that all capacitors have discharg

NOTICE:

Operating Under Vacuum!

Failure to follow these instructions will result in compressor failure. Do not operate or apply power to the compressor while under a vacuum.

Perform all of the indicated maintenance procedures at the intervals scheduled. This will prolong the life of the unit and reduce the possibility of costly equipment failure.

Monthly

Conduct the following maintenance inspections once per month.

Check unit wiring to ensure all connections are tight and that the wiring insulation is intact.
Inspect the condenser coils for dirt and debris. If the coils appear dirty, clean them.
With the unit operating in the cooling mode, check the suction and discharge pressures and compare them with Pressure Curve values. Record these readings on the “Maintenance Log,” p. 38.

Source: Trane (www.trane.com)