General • Inspections

Lockout Tagout Procedure

This checklist policy is used for protecting employees who must do service or maintenance on machines or equipment and who could be injured by an unexpected start-up or release of hazardous energy. This policy will ensure that machinery or equipment is stopped, isolated from all hazardous energy sources, and properly locked or tagged out.

MaintainX

07/26/2022

Lockout Tagout Procedure

Preparation

Prepare for a shut down of energy source. Identify the type of energy used (e.g. electrical) and the potential risks, considering the type and magnitude of the energy and how it can be controlled.

Notification

Locate the isolator(s) and prepare to ‘lock off’ energy source. Inform any operators and supervisors who may be affected by isolating the machinery and make them aware of the work being carried out. Ensure all affected staff understand the lockout procedure.

Shut-down

Turn off the equipment or machine, following established procedures and ensuring that there are no increased hazards from equipment stoppage. Isolate equipment from energy sources, by disconnecting switches, circuit breakers, valves etc. Any stored energy in the equipment should be released, for example by bleeding off pressure, allowing equipment to cool, discharging capacitors, draining lines, or any other methods specified in lockout procedures for individual machines.

Lock Off

Lock off all energy sources in the safe/off position, at each isolating device, using the proper lockout devices. Apply a lock so no one can turn the switch or valve whilst the work is in progress. Warn against accidental use by attaching lockout warning tags. If several employees are working on the same equipment, make sure each puts in place their own identification label and own safety padlock.

Test

Check all of the machine controls and electrical circuits to ensure energy is completely isolated. (Release stored energy, verify machine in ‘zero energy state’- operate controls to verify isolated before returning to ‘off’ position. Could include reading pressure/temperature gauges, using test equipment)

Repair or rework

Perform maintenance/servicing/repairs.

Return to service

When the work is completed take off the lockout/tagout devices and proceed to test, ensuring that all tools and mechanical and electrical lockout devices have been removed. Lockout devices must be only be removed by the person who applied them- if several employees are working on the same piece of equipment, the team supervisor must remove their lockout device last. Warn all workers before re-energising, check the work area to ensure all employees are at a safe distance from the equipment, and restore the e

Source: MaintainX (Community Member)