General • Maintenance

Generac Diesel Generators MMG45FHKCAN6: Every 50 Hours Maintenance (Kubota Engine)

This procedure is for the basic maintenance of your equipment that helps maintain your units excellent performance. By following the recommended interval schedule maintenance, your unit will perform at its most efficient for a long period of time. This procedure focuses on checking the fuel pipes and clamp bands, drain water separator and changing the engine oi.

MaintainX

10/24/2021

Generac Diesel Generators MMG45FHKCAN6: Every 50 Hours Maintenance (Kubota Engine)

Notice!

Refer to the original equipment manufacturer’s operating manual for a complete list of maintenance requirements. Failure to comply with the procedures as described in the engine operator’s manual will nullify the warranty, decrease performance and cause equipment damage or premature equipment failure.

Use the schedule in the following table as a guide for regular maintenance intervals. For additional or replacement copies of the engine operator’s manual, contact an authorized dealer in your area.

Kubota Engine Maintenance Schedule:

Check fuel pipes and clamp bands
Drain Water Separator
Change Engine Oil (Change the engine oil and oil filter after the initial 50 hours of operation, then at the appropriate interval thereafter.)
Replace Oil Filter Cartridge (Change the engine oil and oil filter after the initial 50 hours of operation, then at the appropriate interval thereafter)

Source: Generac (www.generacmobileproducts.com)

Notice!

Use the schedule in the following table as a guide for regular maintenance intervals. For additional or replacement copies of the engine operator’s manual, contact an authorized dealer in your area.

Kubota Engine Maintenance Schedule:

Check fuel pipes and clamp bands

Drain Water Separator

Change Engine Oil (Change the engine oil and oil filter after the initial 50 hours of operation, then at the appropriate interval thereafter.)

Replace Oil Filter Cartridge (Change the engine oil and oil filter after the initial 50 hours of operation, then at the appropriate interval thereafter)