JLG Telehandlers 3510PS: Pre-Opertation Check and Inspection

Use this checklist to help prevent potential safety issues that could be caused by malfunctioning or damaged equipment. Things like hydraulic failure, stability issues, and other issues that can increase the risk of a tip-over or other safety incident.

MaintainX

10/11/2022

JLG Telehandlers 3510PS: Pre-Opertation Check and Inspection

The pre-operation check and inspection, performed at beginning of each work shift or at each change of operator, should include the following:

Cleanliness

Check all surfaces for leakage (oil, fuel or battery fluid) or foreign objects. Report any leakage to the proper maintenance personnel.

Structure

Inspect the machine structure for dents, damage, weld or parent metal cracks or other discrepancies.

Safety Decals

Ensure all safety decals are legible and in place. Clean or replace as required. See page 2-3 for details.

Operation and Safety Manuals

Operation & Safety Manual and AEM Safety Manual (ANSI only) located in cab manual holder.

Walk-Around Inspection

https://csapps.jlg.com/OnlineManuals/Manuals/JLG/JLG%20Telehandlers/3507PS/Operation%20Manuals/Operation_31211081_12-13-16_CE-AUS_English.pdf

See page 2-10 for details.

Fluid Levels

Check fluids, including fuel, diesel exhaust fluid (DEF), hydraulic oil, engine oil and coolant. When adding fluids, refer to Section 7- Lubrication and Maintenance and Section 9 - Specifications to determine proper type and intervals. Before removing filler caps or fill plugs, wipe all dirt and grease away from the ports. If dirt enters these ports, it can severely reduce component life.

Attachments/Accessories

Ensure correct capacity charts are installed on telehandler. If provided, reference Operation & Safety Manual of each attachment or accessory installed for specific inspection, operation and maintenance instructions.

8. Operational Check

Once the walk-around inspection is complete, perform a warmup and operational check (see page 2-13) of all systems in an area free of overhead and ground level obstructions. See Section 3- Controls and Indicators for more specific operating instructions.

Source: MaintainX (Community Member)

The pre-operation check and inspection, performed at beginning of each work shift or at each change of operator, should include the following:

Cleanliness

Check all surfaces for leakage (oil, fuel or battery fluid) or foreign objects. Report any leakage to the proper maintenance personnel.

Structure

Inspect the machine structure for dents, damage, weld or parent metal cracks or other discrepancies.

Safety Decals

Ensure all safety decals are legible and in place. Clean or replace as required. See page 2-3 for details.

Operation and Safety Manuals

Operation & Safety Manual and AEM Safety Manual (ANSI only) located in cab manual holder.

Walk-Around Inspection

See page 2-10 for details.

Fluid Levels

Attachments/Accessories

Ensure correct capacity charts are installed on telehandler. If provided, reference Operation & Safety Manual of each attachment or accessory installed for specific inspection, operation and maintenance instructions.

8. Operational Check

Once the walk-around inspection is complete, perform a warmup and operational check (see page 2-13) of all systems in an area free of overhead and ground level obstructions. See Section 3- Controls and Indicators for more specific operating instructions.