General • Maintenance

Daikin Custom Air Handler Vision CAC/CAH: Every 2000 Hours Maintenance

This procedure if for your equipment's supply and return fans—Supply and return fan motors should have grease added after every 2000 hours of operation. This will help maintain your equipment's stability and high performance.

MaintainX

10/24/2021

Daikin Custom Air Handler Vision CAC/CAH: Every 2000 Hours Maintenance

Motor Bearings

Supply and return fans—Supply and return fan motors should have grease added after every 2000 hours of operation. Using the following procedure, re-lubricate the bearings while the motor is warm, but not running.

Use one of the greases shown in Table 35.

Remove and clean upper and lower grease plugs.
Insert a grease fitting into the upper hole and add clean grease (Table 35) with a low pressure gun.
Run the motor for five minutes before replacing the plugs.

NOTE: Specific greasing instructions are located on a tag attached to the motor. If special lubrication instructions are on the motor, they supersede all other instructions.

Table 36: Lubrication Intervals

Source: Daikin (oslo.daikinapplied.com)

Motor Bearings

Supply and return fans—Supply and return fan motors should have grease added after every 2000 hours of operation. Using the following procedure, re-lubricate the bearings while the motor is warm, but not running.

Use one of the greases shown in Table 35.

Remove and clean upper and lower grease plugs.

Insert a grease fitting into the upper hole and add clean grease (Table 35) with a low pressure gun.

Run the motor for five minutes before replacing the plugs.

NOTE: Specific greasing instructions are located on a tag attached to the motor. If special lubrication instructions are on the motor, they supersede all other instructions.

Table 36: Lubrication Intervals