JLG | Scissor Lifts 1932R - Function Check

Perform the Function Check as follows:

From the Ground Control Panel with no load in the platform

• Ensure that the key selector switch and the platform lift switch operates properly.

• Ensure that all machine functions are disabled when the Emergency Stop Button is depressed.

• With platform raised a few feet (1 m), ensure that the manual descent control (T-handle located at the left rear of the machine, next to the battery charger) lowers the platform properly.

• Check that pot-hole-protection system bars are fully lowered when the platform is raised.

From the Platform Control Console

• Ensure that the control console is firmly secured in the proper location

• Ensure that all guards protecting switches are in place

• Operate all switch functions, drive/lift mode select switch, and horn button.

• Operate all platform joystick functions to ensure proper operation of drive, lift, steer, and enable trigger switch operation.

• Ensure that all machine functions are disabled when the platform Emergency Stop Button is depressed

• With the platform elevated on a smooth, firm, level surface with no overhead obstructions, drive the machine to check if the high drive cutback speed-limit is engaged at the height indicated in Table 2-2. Ensure drive speed is reduced from a top speed to a slower speed.

With the platform in the transport (stowed) position.

• Drive the machine on a grade, not to exceed the rated gradeability, and stop to ensure the drive motor brakes hold.

• Check the tilt indicator light to ensure proper operation. The light should be illuminated if tilted beyond allowed settings in Table 2-3.

NOTE: When the tilt indicator warning is activated the following functions are affected; drive and lift up functions are disabled, platform must be fully lowered (stowed) to drive