Skid steer service (A) 250hr (minor)
Use this checklist as a service schedule guide for the correct maintenance of your Skid Steer. Maintenance work must be done at regular intervals. Failure to do so will result in excessive wear and early failures.
Brisbane Diesel
05/01/2023
Skid steer service (A) 250hr (minor)
Use this checklist as a service schedule guide for the correct maintenance of your Skid Steer. Maintenance work must be done at regular intervals. Failure to do so will result in excessive wear and early failures.
PRE-SERVICE CHECKS
LUBE SERVICE
Fill washer bottle
Change engine oil & filter
Drain separator bowl
Clean air filters
Change final drive oil
Grease machine & change out any no receptive nipples
Adjust track tension
CABIN INSPECTIONS
Check mirrors
Check door seals
Check rubber floor mats
Check pedals (if applicable)
Check operator seat condition
Check seat belt/bar function
Check windows for cracks / stone chips
Check hood lining
Check arm rests
Check A/C louvers
Check AM/FM radio
Check UHF radios
Check display screen for faults & reset service intervals
Start machine and test e-stops
Check joystick neutral position
Test lockout lever function
Function test all operations and test for boom creep
Check Air conditioning functions
Check rotating beacon
Check auto idle function
Check light function
Complete movement checks on boom joints
Remove attachment
setup in service position, roll cabin, engage boom lock & shut down
IMPLEMENT INSPECTION
Check attachment G.E.T condition and report
Check attachments for cracks
Check hitch for cracks
Check boom arms for cracks and defects
Check hydraulic all hoses/tubes
Check all hydraulic cylinders for leaks and rod damage
Check condition of cylinder covers (if applicable)
UPPER STRUCTURE
Check for panel damage and report
Check and lubricate door hinges and struts
Check electrical harnesses
Check battery voltage and load test
Check for leaks under cabin
Check belly guards
Check coolant level
Check hydraulic oil level
Check fan belts
Check ROPS / FOPS
Check covers on upper structure
Check intake system clamps and hoses and mounting
Check exhaust clamps tubes and mounting
Check fuel hoses for rubbing
Check engine / pump mount condition
Check guards around fan
Clean coolers out
Check all hosing / tubes
Check extinguishers (in date and has pressure)
Check control solenoid valves and pumps for leaks and rubbing on harnesses
UNDERCARRAIGE INSPECTION
Inspect hoses to travel motors
Inspect LH sprocket/ roller condition for scalloping
Inspect LH track assembly and report condition
Inspect LH idler condition
Inspect LH load rollers
Inspect LH carrier rollers
Inspect RH sprocket/ roller condition for scalloping
Inspect RH track assembly and report condition
Inspect RH idler condition
Inspect RH load rollers
Inspect RH carrier rollers
Check track frames for cracks
POST SERVICE CHECKS
Fill out sample slips and post
Clean up oil trays
Run up machine and get to operating temperature and check over machine
Record labour
Fill out service sticker fit to window
Source: Brisbane Diesel (Community Member)