Back
Manufacturing / Industrial • Maintenance

2015 DOOSAN G20SC-5 Pneumatic Forklift 500 Hours /3 Months

The 2015 DOOSAN G20SC-5 Pneumatic Forklift 500 Hours /3 Months is a preventive maintenance form done every quarter. It contributes to a safer working environment and prevent costly lift truck repairs. Maximize your forklifts capabilities by consistently performing maintenance.
MaintainX
04/26/2021

2015 DOOSAN G20SC-5 Pneumatic Forklift 500 Hours /3 Months

The 2015 DOOSAN G20SC-5 Pneumatic Forklift 500 Hours /3 Months is a preventive maintenance form done every quarter. It contributes to a safer working environment and prevent costly lift truck repairs. Maximize your forklifts capabilities by consistently performing maintenance.

    You must read and understand the warnings and instructions contained in the Safety section of this manual, before performing any operation or maintenance procedures.

    Belts - Check, Adjust

    • 92.PNG

    NOTICE: Failure to loosen the alternator mounting bolt will cause excessive stress and break the alter- nator mounting ear.

    Tilt Cylinders - Check, Adjust, Lubricate

    Chassis Pivot Eyebolts - Lubricate

    • 93.PNG

    Mast Pivot Eyes-Lubricate

    Cylinder Rod Extension-Adjust

    NOTE : The following description is for forward tilt. For cylinder rod back tilt, the collar should be stationary by the tilt eye.

    If it is not, the O-ring inside the collar may need to be replaced. To adjust back tilt, spacers must be added or removed.

    • 95.PNG

    Mast Hinge Pin - Lubricate

    Crosshead Roller - Inspect

    • 98.PNG

    Parking Brake - Test, Adjust

    See topic, “Parking Brake - Test, Adjust” in “First 50-100 Service Hours.”

    Inching & Braking Control Shaft - Lubricate

    Drive Axle Oil (OCDB) - Change

    See topic, “Drive Axle Oil - Change” in the “First 50 - 100 Service Hours”.

    Horn & Lights (If Equipped) - Check

    Overhead Guard - Inspect

    Inspect Vacuum Lines and Fittings (G420F(E) Engine Only)

    • 101.PNG

    Fuel Trim Valve(FTV) Inspection (G420F(E) Engine Only)

    Inspect Electrical System (G420F(E) Engine Only)

Source: Doosan

Please note that any procedure, checklist, or other document available in the MaintainX Procedure Hub is provided for general education and information only and does not constitute legal, medical, or financial advice. MaintainX makes the materials available AS IS and AS PROVIDED, without warranties of any kind. By downloading or using any such materials, you assume the risk that they may not be appropriate for your specific situation and agree that you are solely responsible for any such use, including compliance with applicable law and with meeting any conditions of product warranties.