General • Inspections

Zebra Invoice/Panda Printer and Applicator PM Procedure

Be Sure to Follow Proper LOTO Procedures, and Always Use Proper PPE.

EssilorLuxottica Maintenance

05/23/2023

Zebra Invoice/Panda Printer and Applicator PM Procedure

Be Sure to Follow Proper LOTO Procedures, and Always Use Proper PPE.

Safety Procedures

Turn Power off to unit.
Turn Air off to unit.

Cleaning Procedures

Clean all rollers by removing glue build up and debris. Use printer wipes.

Clean tamp pad.

Yes
No
N / A

Blow out inside and outside of unit with air hose or canned air.

Use printer wipes to clean print head to remove glue/wax build up.

Check and drain any oil from air regulator bowl. (This can be done by slowly opening port at bottom of bowl)

Visual Inspections

Check that air regulator is set at proper PSI ( Range 65-85psi, 75-80psi is ideal )

Pass
Flag
Fail

Check that brake is in good shape and functioning properly.

Yes
No
N / A

Check rewind belt for damage, or stretch. ( Located behind rewind roller plate )

Yes
No
N / A

Final Check

Print test page that will allow you to check quality of print head. To do this when turning printer on hold feed button simultaneously, continue holding feed button until printer prints a test sheet ( Do Not release feed button before test page prints or you will have to repeat this entire step ). Inspect test sheet and if test sheet has lines in it try to clean again and if still present replace print head. Attach test print to this step.

Add or drag pictures

After printing test page turn printer off and let it completely shut down then turn back on. This will get printer out of test mode.

Make sure power and air is turned back on.

Manual feed a couple labels and actuate the tamp pad to test for proper function.

By signing you acknowledge that all steps above have been properly completed to the best of your ability and that printer is ready to be released to operations without any issues.

Click here to sign

Source: EssilorLuxottica Maintenance (Community Member)