Halter Trailer Departure Checklist

Halter Trailer Inspection Check

-Check Tires -Check hitch for any signs of cracks or breakages - Check all lighting (Blinkers/marker lights/brake lights/etc.) when hitched up

• Pass
• Flag
• Fail

CVET Halter Trailer

• Shut down power inside trailer- (Circuit breaker panel)

• Disconnect/Remove extension cords from the trailer and generator

• Pull main electrical cord back into trailer through port hole in the floor

• Remove water hose from trailer (Swivels to disconnect)

• Remove cap from grey water tank (Swivels left to remove)

• Drain (ALL) water from grey water tank using pull handle under the trailer

• Replace cap back onto water drain line

• E-track Milwaukee box with the Dyson air purifier to the wall

• Bungee books in place

• Secure and bungee the plastic containers (McKesson Mount on the side of the sink)

• Use E-tracks to tie down Husky tool box and Dewalt together (top e-track to bottom e-track)

• Tie shelving unit, with E-track, to the wall with upper e-track and lower e-track

• Secure bucket of platinum and foldable shelf unit with lower shelf e-track

• Secure the foldable shelf unit with the upper e-track used for the rolling shelf unit

• Bungee the items on the top of the rolling shelf unit to hold them down

• Bungee each layer of the rolling shelf so no bins can roll out

• Secure all loose items or place on floor (Tie things together or to the wall if possible)

• Check that medical lights are bungeed and stowed away properly

• Place mobile white board in the sink for transporting

• Latch and close all doors

• Lock main door latch by turning key to the right and then remove the key

• Latch deadbolt , bottom key lock, by turning all the way over to the left then back to the middle then remove the key

• Hook up pickup to trailer

• Please see "attaching pickup to trailer checklist" for more direction