Back
General • Inspections

Shop Garage Door LOTO Procedure: Construction Electrical

This Lock out/Tag Out procedures establish the minimum requirements for lockout/tagout (LO/TO) on equipment that is being serviced or maintained. This procedure must be followed in order to properly stop equipment, disconnect it from any sources of potentially hazardous energy, and prevent those sources from being reconnected during the work.
MaintainX
07/26/2022

Shop Garage Door LOTO Procedure: Construction Electrical

This Lock out/Tag Out procedures establish the minimum requirements for lockout/tagout (LO/TO) on equipment that is being serviced or maintained. This procedure must be followed in order to properly stop equipment, disconnect it from any sources of potentially hazardous energy, and prevent those sources from being reconnected during the work.

    • 1.png

    ENERGY SOURCES

    Energy Source (Magnitude):

    Energy Isolation Point or Control Step:

    Application Method and LOTO Device

    Step #

    • 2.png

    LOCKOUT TAGOUT SEQUENCE

    Notify Employees

    Equipment Shutdown

    Isolate Energy

    Lockout Energy

    Dissipate Energy

    Verify Isolation

    Perform work

    RESTORE EQUIPMENT TO SERVICE SEQUENCE

    Clear Work Area

    Verify Controls

    Remove Lockout

    Notify Employees

Source: MaintainX (Community Member)

Please note that any procedure, checklist, or other document available in the MaintainX Procedure Hub is provided for general education and information only and does not constitute legal, medical, or financial advice. MaintainX makes the materials available AS IS and AS PROVIDED, without warranties of any kind. By downloading or using any such materials, you assume the risk that they may not be appropriate for your specific situation and agree that you are solely responsible for any such use, including compliance with applicable law and with meeting any conditions of product warranties.