Walinga Ultra-Vac Unit 4510G 8 Hours / Daily Maintenance

Maintenance Safety

Follow good shop practice:

5.1.3 SERVICING INTERVALS

Fig. 5-1 Blower End Views

Fig. 5-2 Gear End

Fig 5-3 Drive End

5.2.1 BELT TENSION AND ALIGNMENT

Table 4 Belt Deflection

Follow this procedure when checking and adjusting belt tension and pulley alignment.

Fig. 5-10 Deflection

Adjusting Tension:

Warning : Machine is shown with guard removed for illustrative purposes only. Do not operate machine with guard removed.

Fig. 5-11 Tension Adjustment

Pulley Alignment:

Fig. 5-12 Misalignment

5.2.2 BLOWER OIL CHANGING AND BREATHER CLEANING

The gears that drive and time the blower lobes run in an oil bath for lubrication. Maintaining the correct level in the reservoirs and changing every 100 hours will insure proper lubrication.

When maintaining the blower, follow this procedure:

Checking Oil Level:

IMPORTANT :Check the level only when the oil is cold and the machine is level.

IMPORTANT : It is necessary to maintain the recommended oil level in the reservoir. A low level causes heating from lack of lubrication and rapid gear and bearing wear. Too much oil causes heating from oil churning and can cause seal and breather leaks.

Fig. 5-13 Blower

Fig. 5-14 Blower

Changing Oil:

IMPORTANT : Condensation forms and collects inside the reservoirs during machine operation. Changing oil removes this water and prevents it from damaging the gears and bearings

Cleaning Breathers:

Fig. 5-15 Blower

Fig. 5-16 Breathers