Doosan D30S-5 Pneumatic Forklift 500 Hours /3 Months
The Doosan D30S-5 Pneumatic Forklift 500 Hours /3 Months ensures the quality performance of your forklift by identifying parts to replace/repair. Ensure the lifespan of your is preserved.
Doosan D30S-5 Pneumatic Forklift 500 Hours /3 Months
The Doosan D30S-5 Pneumatic Forklift 500 Hours /3 Months ensures the quality performance of your forklift by identifying parts to replace/repair. Ensure the lifespan of your is preserved.
Belts - Check, Adjust
NOTICE Failure to loosen the alternator mounting bolt (2) will cause excessive stress and break the alternator mounting ear.
Mast Hinge Pin – Lubricate
Tilt Cylinders - Check, Adjust, Lubricate
Chassis Pivot Eye bolts-Lubricate
Mast Pivot Eyes-Lubricate
Cylinder Rod Extension-Adjust
NOTE: The following description is for forward tilt. For cylinder rod back tilt, the collar should be stationary by the tilt eye. If it is not, the O-ring inside the collar may need to be replaced. To adjust back tilt, spacers must be added or removed.
Crosshead Rollers - Inspect
Check Operation
Operate the mast through a lift cycle. Watch the chains move over the crosshead rollers. Make sure the chain is tracking over the rollers properly.
Transmission Oil Filter – Change
WARNING:Hot oil and components can cause personal injury. Do not allow hot oil or components to contact skin.
Park the lift truck level, with the forks lowered, parking brake engaged, direction control lever in NEUTRAL and the engine stopped.
Overhead Guard – Inspect
Drive Axle Oil & Strainer - Change, Clean
Park the lift truck level, with the forks lowered, parking brake engaged, transmission in NEUTRAL and engine stopped.
Steer Suspension – Inspect
Parking Brake - Test, Adjust
Inching & Braking Control Shaft - Lubricate
Horn and Lights (If Equipped) - Check
Source: Doosan