Back
Property Management • Maintenance

Bryant Heating and Cooling System Heat Pump 288BNV 3 Months Maintenance

The Bryant Heating and Cooling System Heat Pump 288BNV 3 Months Maintenance is a quarterly preventive maintenance form that is simple and straightforward. It provides a checklist for thorough inspections assuring you quality performance by your equipment. Follow the precautionary measures in the form to avoid risks and ensure safety.
MaintainX
04/26/2021

Bryant Heating and Cooling System Heat Pump 288BNV 3 Months Maintenance

The Bryant Heating and Cooling System Heat Pump 288BNV 3 Months Maintenance is a quarterly preventive maintenance form that is simple and straightforward. It provides a checklist for thorough inspections assuring you quality performance by your equipment. Follow the precautionary measures in the form to avoid risks and ensure safety.

    WARNING: ELECTRICAL SHOCK HAZARD Failure to follow this warning could result in personal injury or death. Before installing, modifying, or servicing system, main electrical disconnect switch must be in the OFF position. There may be more than 1 disconnect

    NOTE: There may be more than one electrical disconnect switch.

    Fig. 1 -- Electrical Disconnects

    CAUTION: CUT HAZARD Failure to follow this caution may result in personal injury. Although special care has been taken to minimize sharp edges in the construction of your unit, be extremely careful and wear appropriate protective clothing and gloves when

    Keep Filter Clean

    Do Not Block Floor, Wall or Ceiling Vents

    Do Not Cover or Block Outdoor Unit

    Check Condensate Drain

    Do Not Operate Below Minimum Operating Temperatures in Cooling Mode

    Your outdoor unit is not designed to operate below the minimum temperatures shown below. The minimum temperature depends on which wall control is being used:

    System protections may not allow the unit to operate below these minimum temperatures.

    Do Not Operate Above 66°F/18.89_C in Heating Mode

    Minimum Heating Temperature

    Base Pan Drainage

    Level Installation

    SEA COAST COIL MAINTENANCE

    Coastal locations often require additional maintenance of the outdoor unit due to highly corrosive airborne ocean salt. Although your new Bryant system is made of galvanized metal and is protected by top--grade paint, take the additional precaution of per

    TROUBLESHOOTING

    Before you request dealer service, check for these easily solved problems:

    If you need to contact your Bryant dealer for troubleshooting and/or repairs, be sure to have the model and serial numbers of your equipment available (there are spaces on the cover for you to write this information)

    REGULAR DEALER MAINTENANCE

    In addition to the routine maintenance that you perform, your home comfort system should be inspected regularly by a properly trained service technician. Many dealers offer this service at a reduced rate with a service contract. Some service contracts off

    Your annual system inspection should include:

Source: Bryant

Please note that any procedure, checklist, or other document available in the MaintainX Procedure Hub is provided for general education and information only and does not constitute legal, medical, or financial advice. MaintainX makes the materials available AS IS and AS PROVIDED, without warranties of any kind. By downloading or using any such materials, you assume the risk that they may not be appropriate for your specific situation and agree that you are solely responsible for any such use, including compliance with applicable law and with meeting any conditions of product warranties.