BUNN | LCR-2 (with Scholle 1910 3/16") - Weekly Cleaning & Preventive Maintenance Instructions

Weekly: SANITIZING

• 1. Open the dispenser door

• 2. Select Prime on the Function Selector Switch and Run on the Mode Selector Switch.

• 3. Remove the bag connector from the product box and disassemble or prop open the internal valve to allow free flow of product through the connector.

• NOTE: Cutting the mating fittings from an empty bag makes an excellent “free flowing” connector for this purpose.

• 4. Place the bag connector into a one-gallon (3.8 liter) container of warm soapy tap water 140°F (60°C).

• 5. Place an empty container under dispense tip and activate the corresponding dispenser until the clean soapy water is dispensed from the dispense tip.

• 6. Repeat steps 4 and 5 with warm tap water 140°F (60°C) to rinse the soapy water from the pump tubing. Continue dispensing until the water is clear, and no soapy water is being dispensed.

• 7. Prepare 2.5 gallons (9.46L) of sanitizing solution by dissolving 1 packet of Kay 5 sanitizer into 2.5 gallons (9.46L) of 120°F (48.9°C) water to ensure 100 ppm of available chlorine.

• 8. Again, repeat steps 4 and 5 with the sanitizing solution. Once sanitizing solution is visible, continue to dispense for 1 minute. Release handle and allow solution to sit for 5 minutes.

• 9. After soaking for 5 minutes, activate the dispense switch a second time, this time for 2 minutes. After 2 minutes, release the dispense switch.

• 10. Repeat step 6 to flush out the sanitizing solution from the pump tubing.

• 11. Remove the mating connector from the bag connector

• 12. Reattach the bag connector to product box

• 13. Select Normal on the Function Selector Switch and Run on the Mode Selector Switch.

• 14. Activate the dispenser until concentrate/water mixture appears. Then dispense one 12 ounce (354.9 ml) glass of concentrate/water mixture and discard.

• 15. Repeat steps 1 through 14 for other dispense head.

• 16. Wipe internal and external surfaces with a clean, damp cloth.

Weekly: REFRIGERATION AIR FILTER

• Remove the screen filter from the back of the dispenser.

• Wash the screen in a mild detergent solution.

• Use a soft bristled brush to remove all dust and grease

• Reinstall the screen on the back of the dispenser.

PREVENTIVE MAINTENANCE

• Bunn-O-Matic® Corporation recommends that preventive maintenance be performed at regular intervals. Maintenance should be performed by a qualified service technician. For Technical Service, contact Bunn-O-Matic® Corporation at 1-800-286-6070.

• NOTE: Replacement parts or service caused by failure to perform required maintenance is not covered by warranty. Replace pump hoses every 6-Months or as needed.