Back
Manufacturing / Industrial • Maintenance

2015 DOOSAN G20SC-5 Pneumatic Forklifts 2000 Hours / 1 Year

The 2015 DOOSAN G20SC-5 Pneumatic Forklifts 2000 Hours / 1 Year is a preventive maintenance form done annually. It contributes to a safer working environment and prevent costly lift truck repairs. Maximize your forklifts capabilities by consistently performing maintenance.
MaintainX
04/26/2021

2015 DOOSAN G20SC-5 Pneumatic Forklifts 2000 Hours / 1 Year

The 2015 DOOSAN G20SC-5 Pneumatic Forklifts 2000 Hours / 1 Year is a preventive maintenance form done annually. It contributes to a safer working environment and prevent costly lift truck repairs. Maximize your forklifts capabilities by consistently performing maintenance.

    You must read and understand the warnings and instructions contained in the Safety section of this manual, before performing any operation or maintenance procedures.

    Steer Wheel Bearings – Reassemble

    Park the lift truck level with the forks lowered, park- ing brake engaged, transmission in NEUTRAL and the engine stopped.

    • 2.PNG
    • 3.PNG
    • 4.PNG

    NOTE : Deflate tire before removing wheel nuts from the truck.

    • 5.PNG

    Drive Wheel Bearing - Reassemble

    Consult your DOOSAN lift truck dealer for the proper wheel bearing reassembling procedure.

    Reassembling of bearings and adjustment procedure must be made by a trained mechanic or deal- er personnel.

    Cooling System – Clean, Change

    WARNING: At operating temperature, the engine coolant is hot and under pressure. Steam can cause personal injury.

    Check the coolant level only after the engine has been stopped and the filler cap is cool enough to touch with your bare hand. Remove the filler cap slowly to relieve pressure.

    Coolant is included antifreeze for forbidding corrosion. Avoid contact with the skin and eyes to prevent personal injury. Use all cleaning solution with care.

    The Lift truck must be level, the forks lowered, the parking brake engaged, the transmission in NEUTRAL and the engine stopped and cool.

    • 7.PNG

    V2403 Diesel Engine

    G420F(E) 2.0L LPG/Gasoline Engine

    • 10.PNG

    NOTICE: Hold the drain port when the radiator drain valve is turned because the tank and the drain port are separated.

    Fork - Inspect

    Forks should be inspected, at a minimum, every 12 months. If the truck is being used in a multi-shift or heavy duty operation, they should be checked every six months.

    • 12.PNG
    • 13.PNG
    • 14.PNG
    • 15.PNG
    • 16.PNG
    • 17.PNG
Source: Doosan

Please note that any procedure, checklist, or other document available in the MaintainX Procedure Hub is provided for general education and information only and does not constitute legal, medical, or financial advice. MaintainX makes the materials available AS IS and AS PROVIDED, without warranties of any kind. By downloading or using any such materials, you assume the risk that they may not be appropriate for your specific situation and agree that you are solely responsible for any such use, including compliance with applicable law and with meeting any conditions of product warranties.