Back
Manufacturing / Industrial • Maintenance

2013 HYSTER H50FT Pneumatic Tire 2000 Hours / 1 Year

The 2013 HYSTER H50FT Pneumatic Tire 2000 Hours / 1 Year form focuses on different filters. The form provides a compartmentalized list for different filters such as hydraulic oil, air, fuel and brake fluid. This form is used when you need to do a preventive maintenance annually.
MaintainX
04/26/2021

2013 HYSTER H50FT Pneumatic Tire 2000 Hours / 1 Year

The 2013 HYSTER H50FT Pneumatic Tire 2000 Hours / 1 Year form focuses on different filters. The form provides a compartmentalized list for different filters such as hydraulic oil, air, fuel and brake fluid. This form is used when you need to do a preventive maintenance annually.

    HYDRAULIC OIL FILTER

    WARNING: At operating temperature the hydraulic oil is HOT. Do not permit the hot oil to touch the skin and cause a burn.

    CAUTION :Do not permit dirt to enter the hydraulic system when the oil level is checked or the filter is changed.

    Never operate the hydraulic pump without oil in the hydraulic system. The operation of the hydraulic pump without oil will damage the pump.

    AIR FILTER

    The air filter canister should not be opened until an air filter element replacement is required. An air filter element replacement is required when one of the following occurs:

    Do not operate the lift truck until the air filter element has been replaced.

    FUEL FILTER

    FUEL INJECTOR

    FUEL INJECTOR

    TRANSMISSION OIL

    TRANSMISSION OIL

    FORKS

    NOTE: Forks must be removed or installed by trained per- sonnel only.

    Figure 47. Forks Check

    MAST

    MAST

    BRAKE FLUID

    WARNING: Small amounts of water in the brake system can cause reduced braking performance if the water reaches the wheel cylinder area. Do not allow water entry, ensure that the sealed reservoir lid is properly replaced. If the brake system has a power as

    On lift trucks with wet brake drive axles, only use Dex- ron III oil from sealed container in the master cylinder. On lift trucks with dry brake drive axles, only use SAE J-1703 (DOT 3) brake fluid in the master cylinder.

    Loss of fluid from the brake fluid reservoir indicates a leak. Repair the brake system before using the lift truck. Replace the brake fluid in the system if there is dirt or water in the system. Failure to observe the above warnings could result in death

    BRAKE OIL

    SERVICE BRAKES

    Check Lining Thickness.

    Dry Brakes S40-70FT, S55FTS (F187)

    Dry Brakes H40-70FT (L177)

    TRANSMISSION OIL

    TRANSMISSION OIL

    LEFT SIDE

    RIGHT SIDE

Source: Hyster

Please note that any procedure, checklist, or other document available in the MaintainX Procedure Hub is provided for general education and information only and does not constitute legal, medical, or financial advice. MaintainX makes the materials available AS IS and AS PROVIDED, without warranties of any kind. By downloading or using any such materials, you assume the risk that they may not be appropriate for your specific situation and agree that you are solely responsible for any such use, including compliance with applicable law and with meeting any conditions of product warranties.