Anycubic Wash & Cure Maintence
This procedure will help maintain the Wash & Cure Max Machine in proper working condition by performing regular cleaning, and inspections.
Conestoga College - SMART Centre
10/15/2024
Anycubic Wash & Cure Maintence
This procedure will help maintain the Wash & Cure Max Machine in proper working condition by performing regular cleaning, and inspections.
Maintence
Wastes Disposal
The waste liquid is the combination of water, a little resin and little detergent. It should be disposed of before being discarded.
1. Allow the solvent to stay still for over 10 hours so the residue can be precipitated and settled. 2. Pour the top layer of liquid into the drainer and then expose the residue to the sunlight. Then, the cured resin can be handled as general solid waste.
Recycling of detergent
The solvent in the detergent container might become muddy after a long time of washing. The solvent can be recycled through the following treatment. (It is recommended to dispose of or replace the solvent after one month/washing 20, 10.1" height models, to ensure the washing effect.)
1. Pour the solvent into another bucket and allow it to stay still for over 10 hours so the residue can be precipitated and settled. At this time, you can clean the detergent container with water. 2. Filter the top layer of solvent and pour it into the detergent container. Then, cover the container. 3. Expose the residue in the sunlight. Then, the cured resin can be handled as general solid waste.
Cleaning
Please turn off the machine and unplug the power before cleaning.
If the rotor rotates abnormally after long-term use, you can remove the rotor from the drum to clean it. 1. Open the door, and remove the rotor at the bottom of the drum. 2. Clean the rotor. Then, install the rotor
Please clean the strainers periodically to avoid the residue and other foreign matters blocking it. 1. Open the door and take out the two strainers at the bottom of the drum. 2. Clean the strainers with a brush. 3. Install the two strainers.
Pour water into the drum and clean it with the plastic scraper. Never scratch the inner wall with sharp objects. After cleaning, plug in the power and turn on the machine. Long press the CANCEL button for 3 seconds and then It will drain off the waste water.
Please clean the filter periodically to avoid foreign matters blocking it. 1. Open the lid and take out the filter. (The pictures here take the detergent container as an example.) 2. Clean the filter with a brush. If the filter has been used for over 3 months or is hard to clean, please replace it. 3. Install the filter.
Please clean the machine before it is left unused for a long time. If accessories or parts are being contaminated, clean them according to the instructions above of Cleaning and then overall wash the machine by the steps below. 1. Drain the detergent and water containers, and then wash the containers. 2. Put the pipes 1/2/3 into a container filled with water. Keep pipe 4 in the bucket. 3. Close the machine door, set the wash & cure mode and then press START/PAUSE button to start the process. 4. When the process is finished, wait until the drum is dry and store the machine in a dark, cool place.
Pipe replacement
If the pipes are broken, please replace them timely.
1. Turn off the machine and unplug the power. 2. Take off the stopper first. Then, press the safety valve of the L-shaped connector and pull out the pipe. 3. Insert the new pipe into the L-shaped connector and then install the stopper.
Source: Conestoga College - SMART Centre (Community Member)