Newco Coffee AK Series Brewer Installation Form

Installation / Setup Instructions

• Place the decanter under brew basket, raise top evaporation cover and pour three decanters of water through the top pour-in screen. Water should come through the brew basket as the third decanter of water drains out of the pour in basin

• Brewer is shipped with thermostat turned on. Plug or wire in machine to appropriate voltage circuit as indicated on serial tag

• Allow 10 to 15 minutes for water in tank to heat to brewing temperature. Additional water may drip from brew basket on initial expansion of water in the tank. This will not occur thereafter

• After water has reached brewing temperature (thermostat will click off, heating noise will stop and green ready light will be on) pour 1 decanter (60 oz.) of water through pour-in screen. More than 1 decanter of water will flow into decanter below brew basket due to water expansion in the tank. Machine is now ready to use

• Pour 1 decanter of water through pour-in screen to check for the proper temperature setting with an accurate thermometer. Take the temperature of this water at a point below the brew basket opening, at the start of the brew cycle and when the decanter is half full. Recommended temperature of the water is approximately 195 F

• In higher altitude locations (5000 feet above sea level) the thermostat may have to be adjusted lower to prevent boiling