Randell Chick-Fil-A Refrigerated Breading Table Monthly Preventive Maintenance Form

Condenser Coil Cleaning

• Clean the condenser coils with coil cleaner and/or a vacuum, cleaner and brush

• Open lower louver ventilation door for the compressor compartment and remove mesh filter to view the condenser coil

• Use brush attachment for vacuum in this area to vacuum all particles out of this area

• Brush coil in direction of fins, normally vertically as to not damage or restrict air from passing through condenser

• Remove 8 Phillips screws on right exterior side of compressor compartment to gain access to condensing unit

• Vacuum all loose particles that can be seen being careful not to damage any wires or copper lines

• Clean and disinfect rail drains with a solution of warm water and mild detergent. It is recommended to open and close the drain valve as the hot water is flowing through to clean any debris from the internal valve components.

• Clean and disinfect drain lines and evaporator pan with a solution of warm water and mild detergent

• Remove right side access panel on right end of table

• Remove clear plastic drain line from plastic tray of condensing unit and place pan under end of drain tube

• Discard waste water from pan when cleaning is complete

• Re-insert plastic drain tube into position on condensing unit

• Inspect all silicone seams at interior of the rail and refrigerated base cabinet

• Re-apply food grade silicone sealant as needed to any seams where silicone has peeled away or cracked

• Apply silicone to a clean dry surface

• Allow sufficient drying time to assure best adhesion of sealant