General • Inspections

CenTraVac Water-Cooled Chiller CVHE - Annual Maintenance

Annual maintenance is a simple and cost-effective way to ensure your HVAC system is running at peak efficiency and to catch problems before they get serious.

MaintainX

08/10/2022

CenTraVac Water-Cooled Chiller CVHE - Annual Maintenance

Annual maintenance is a simple and cost-effective way to ensure your HVAC system is running at peak efficiency and to catch problems before they get serious.

Shut down the chiller once each year to check the items listed on the “Appendix D: CVHH CenTraVac™ Chiller Annual Inspection List,” p. 124 (refer to “Appendix A: Forms and Check Sheets,” p. 119).

Perform the annual maintenance procedures referred to in “Maintenance,” p. 111.

Manual Link

Use an ice water bath to verify the accuracy of the evaporator refrigerant temperature sensor (4BT11). If the sensor is exposed to temperature extremes outside its normal operating range (0°F to 90°F [-17.8°C to 32.2°C]), check its accuracy at six-month intervals.

Inspect the condenser tubes for fouling; clean if necessary.

Pass
Flag
Fail

Inspect and clean the ifm efector® flow detection sensors. Use Scotch-Brite® or other non-abrasive material to clean scale; do NOT use steel wool, which could cause the probe to rust.

Pass
Flag
Fail

Submit a sample of the compressor oil to a Tranequalified laboratory for comprehensive analysis.

Measure the compressor motor winding resistance to ground; a qualified service technician should conduct this check to ensure that the findings are properly interpreted. Contact a qualified service organization to leak-test the chiller; this procedure is especially important if the system requires frequent purging.

Source: MaintainX (Community Member)