Guns Preventative Maintenance Program

Health and Safety

• LOTO is Mandatory

• Never work under a Weight (Crush hazard)

• Avoid Pinch points( can cause severe injuries)

• PPE are required

• Inspect all the tools needed

• Once finished always inspect the area

Maintenance

• Disconnect the air supply and the electrical connection from the gun

• Take out the 24mm nut with a Hex wrench

• Place the spare gun following the reverse points mentioned

• Clean the gun thoroughly ( don't forget to clean the nose on the coil nail gun and take out any debris )

• Open and Check for the warn out parts ( inspection )

• Change the damaged parts ( bumpers, piston, drive blade and driver cord on the staple gun, main valve ,screws, nuts )

• Change O-rings for better sealing (O-rings can run for 06 month at a rate of 08 hours a day excluding week-end and holidays)

• Use silicone lubricant on O-rings and sealings ( apply a convenient quantity avoid putting to much )

• Lubricate the gun with 03 drops of pneumatic oil from the main air connector

• Check for the electrical parts/the continuous reload on coil nail gun and staple gun ( 5/2 way valve and the two reload cylinders)

Inspection after work

• Pass
• Flag
• Fail

Technician Signature is Mandatory