General • Inspections

Generac Diesel Generators MMG45FHKCAN6: Every 50 Hours Maintenance (Kubota Engine)

This procedure focuses on checking the fuel pipes and clamp bands of your equipment. Following the recommended interval maintenance will help your equipment run smoothly for a long period of time.

MaintainX

08/24/2022

Generac Diesel Generators MMG45FHKCAN6: Every 50 Hours Maintenance (Kubota Engine)

This procedure focuses on checking the fuel pipes and clamp bands of your equipment. Following the recommended interval maintenance will help your equipment run smoothly for a long period of time.

Notice!

Refer to the original equipment manufacturer’s operating manual for a complete list of maintenance requirements. Failure to comply with the procedures as described in the engine operator’s manual will nullify the warranty, decrease performance and cause equipment damage or premature equipment failure.

Use the schedule in the following table as a guide for regular maintenance intervals. For additional or replacement copies of the engine operator’s manual, contact an authorized dealer in your area.

Kubota Engine Maintenance Schedule:

Check fuel pipes and clamp bands
Drain Water Separator
Change Engine Oil (Change the engine oil and oil filter after the initial 50 hours of operation, then at the appropriate interval thereafter.)
Replace Oil Filter Cartridge (Change the engine oil and oil filter after the initial 50 hours of operation, then at the appropriate interval thereafter)

Source: MaintainX (Community Member)

Notice!

Use the schedule in the following table as a guide for regular maintenance intervals. For additional or replacement copies of the engine operator’s manual, contact an authorized dealer in your area.

Kubota Engine Maintenance Schedule:

Check fuel pipes and clamp bands

Drain Water Separator

Change Engine Oil (Change the engine oil and oil filter after the initial 50 hours of operation, then at the appropriate interval thereafter.)

Replace Oil Filter Cartridge (Change the engine oil and oil filter after the initial 50 hours of operation, then at the appropriate interval thereafter)