Back
General • Inspections

Anycubic Wash & Cure Procedure

This procedure can ensure proper operation of the "Anycubic Wash & Cure Max Machine" for washing and curing 3D printed models effectively and safely.
Conestoga College - SMART Centre
10/15/2024

Anycubic Wash & Cure Procedure

This procedure can ensure proper operation of the "Anycubic Wash & Cure Max Machine" for washing and curing 3D printed models effectively and safely.

    Safety Precautions

    • Screenshot2024-09-19114444.png
    • Screenshot2024-09-19114356.png
    • Screenshot2024-09-19114137.png
    • Screenshot2024-10-15125335.png

    Safety Precautions

    Do not force open the door when the machine is working to avoid the individual injury or environmental damage. Open flames are prohibited. Please keep the machine away from fire and heat to prevent a fire or explosion. In case of emergency, please immediately cut off the power of the machine and contact our technical support. The pipes must be connected properly. Do not frequently plug and unplug the pipe, as the joints may become loose and cause water leakage and other problems. Do not clean or cure the models directly without the tray. The washing solvent should be sealed and stored in a cool and dry place after use. If the solvent is alcohol, please comply with usage specifications of alcohol.

    • istockphoto-1163581975-612x612.jpg
    • sign-24067_1280.webp

    Setup

    Setup

    - Pour more than 4L of detergent into the container - Tighten the lid - Insert the pipes into the lids with the same numbers - Put the container against the machine to avoid it tipping over

    • Screenshot2024-09-13141707.png

    - Fill the container with water - Tighten the lid - Insert the pipes into the lids with the same numbers - Put the container against the machine to avoid tipping over

    • Screenshot2024-09-13141921.png

    Usage

    1. Place the objects in the tray after removing them from the print platform. 2. Press "WASH&CURE" button to select this mode. Then, press "START/PAUSE" button to start the washing and curing process. (The door is locked when the machine is working.) 3. If you have to open the door during washing, the process must be stopped. Press "CANCEL" button and wait for it to finish the current program. Then, open the door. 4. If you have to open the door during curing, press "START/PAUSE" button to pause the process and open the door when the indicator light is green. Then, press "START/PUASE" button to continue the process. 5. A beeping sound indicates the process is finished. Please open the door and take out the printed objects.

    • Screenshot2024-09-13143139.png
Source: Conestoga College - SMART Centre (Community Member)

Please note that any procedure, checklist, or other document available in the MaintainX Procedure Hub is provided for general education and information only and does not constitute legal, medical, or financial advice. MaintainX makes the materials available AS IS and AS PROVIDED, without warranties of any kind. By downloading or using any such materials, you assume the risk that they may not be appropriate for your specific situation and agree that you are solely responsible for any such use, including compliance with applicable law and with meeting any conditions of product warranties.