Back
Manufacturing / Industrial • Maintenance

WALINGA AGRI-VAC UNIT 5614 DLX DAILY/8 HOURS A DAY MAINTENANCE

MaintainX
04/26/2021

WALINGA AGRI-VAC UNIT 5614 DLX DAILY/8 HOURS A DAY MAINTENANCE

    Maintenance Safety

    Follow good shop practices

    5.1 SERVICE

    5.1.1 FLUIDS AND LUBRICANTS

    Grease:

    Use Walinga Blower oil (part# 98-13813-6)

    Storing Lubricants:

    5.1.2 GREASING

    Refer to Section 5.1.1 for recommended grease. Use the Service Record checklist provided to keep a record of all scheduled servicing.

    Fig. 5-1 PTO Shaft Lubrication Points.

    Fig. 5-2 Drive Belts.

    Fig. 5-3 Blower Reservoir Schematics.

    Fig. 5-4 Blower Reservoirs (Front)

    Fig. 5-5 Blower Reservoirs (Rear)

    5.2.1 BELT TENSION AND ALIGNMENT

    Follow this procedure when checking and adjusting the belt tension and the pulley alignment.

    • 1.PNG

    Fig. 5-16 Belt Deflection

    Fig. 5-17 Belt Deflection.

    Adjusting Tension:

    Fig. 5-18 Adjusting Bolts.

    Machine is shown with guard remove for illustrative purposes only. Do not operate machine with guard removed.

    Pulley Alignment:

    Machine is shown with guard removed for illustrative purposes only . Do not operate machine with guard removed.

    Fig. 5-19 Pulleys

    Fig. 5-20 Misalignment

    Fig. 5-21 Adjusting Bolts At Input Shaft.

    Machine is shown with guard removed for illustrative purposes only . Do not operate machine with guard removed.

    Fig. 5-22 Adjusting Anchor Bolts At Bearing Housing Assembly

    5.2.2 BLOWER OIL CHANGING AND BREATHER CLEANING

    The gears that drive and time the blower lobes run in an oil bath for lubrication. Maintaining the correct level in the reservoirs and changing every 100 hours will insure proper lubrication.

    When maintaining the blower, follow this procedure:

    Fig. 5-23 Blower Schematics.

    Checking Oil Level:

    IMPORTANT Check the oil level only when the oil is cold and the machine is level.

    Fig. 5-24 Blower (Rear)

    IMPORTANT: It is necessary to maintain the recommended oil level in the reservoir. A low level causes heating from lack of lubrication and rapid gear and bearing wear. Too much oil causes heating from oil churning and can cause seal and breather leaks.

    Fig. 5-25 Blower (Front)

    5.2.2 BLOWER OIL CHANGING AND BREATHER CLEANING

    Changing Oil:

    IMPORTANT : Condensation forms and collects inside the reservoirs during machine operation. Changing oil removes this water and prevents it from damaging the gears and bearings

    Fig. 5-26 Blower Schematics.

    Cleaning Breathers:

    Fig. 5-27 Breathers

Source: Walinga

Please note that any procedure, checklist, or other document available in the MaintainX Procedure Hub is provided for general education and information only and does not constitute legal, medical, or financial advice. MaintainX makes the materials available AS IS and AS PROVIDED, without warranties of any kind. By downloading or using any such materials, you assume the risk that they may not be appropriate for your specific situation and agree that you are solely responsible for any such use, including compliance with applicable law and with meeting any conditions of product warranties.