CROWN WF 3000-1.0 Pedestrian Stacker ( GENERAL MAINTENANCE)

Failure to do so could result in severe or fatal injuries to maintenance personnel and/or other persons.

Motorised vehicles can be dangerous if maintenance and service are neglected.

For this reason maintenance and inspections must be carried out at regular short intervals by trained personnel working to approved company guide- lines.

Failure to do so could result in severe or fatal injuries to maintenance personnel and/or other persons.

Maintenance work must only be carried out in accordance with the test and maintenance program contained in the present Maintenance Manual and any applicable service notices

Only qualified and authorized personnel may carry out work on the truck.

Always keep fire extinguishers in good working condition. Do not approach fluid levels or leaks with a naked flame.

To clean, use a non flammable, non combustible cleaning solution which is groundwater-neutral. Only carry out cleaning with an oil separator. Protect the electrical system from dampness.

Keep the service area clean, dry and well- ventilated.

Do not allow oil to penetrate the ground or enter the draining system.

Used oil must be recycled. Oil filters and desiccants must be treated as special waste products.

Relevant applicable regulations must be followed.

Neutralize and thoroughly rinse any spilled battery fluid immediately.

Keep the truck clean. This will facilitate the location of loose or faulty components.

Make sure that capacity and data plates, warnings and labels are legible at all times.

Alterations or modifications by the owner or operator are not permitted without the express written authorisation from Crown.

Only use original Crown spare parts to ensure the

reliability
safety
suitability of the Crown truck.

Stop the truck.

Lower the fork carriage fully.

Apply the parking brake.

Turn off the truck and remove the key.

Block all wheels when parking on an uneven surface.

Raise the truck to free the drive wheel. Press the emergency Stop button and disconnect the battery.

Prevent the truck from rolling away.

Before carrying out work on the hoist frame, the lift mast or on the fork carriage:

Block these parts according to maintenance instructions in order to prevent them from dropping.

DANGER: Read the safety notices in the truck Maintenance and Operator's Manuals.

Failure to do so could result in severe or fatal injuries to maintenance personnel and/or other persons.

Motorised vehicles can be dangerous if maintenance and service are neglected.

For this reason maintenance and inspections must be carried out at regular short intervals by trained personnel working to approved company guide- lines.

DANGER: Follow all national/local safety regula- tions applicable for maintenance work, e.g. for work on higher levels.

Failure to do so could result in severe or fatal injuries to maintenance personnel and/or other persons.

Maintenance and Repair

Maintenance work must only be carried out in accordance with the test and maintenance program contained in the present Maintenance Manual and any applicable service notices

Only qualified and authorized personnel may carry out work on the truck.

Always keep fire extinguishers in good working condition. Do not approach fluid levels or leaks with a naked flame.

To clean, use a non flammable, non combustible cleaning solution which is groundwater-neutral. Only carry out cleaning with an oil separator. Protect the electrical system from dampness.

Keep the service area clean, dry and well- ventilated.

Do not allow oil to penetrate the ground or enter the draining system.

Used oil must be recycled. Oil filters and desiccants must be treated as special waste products.

Relevant applicable regulations must be followed.

Neutralize and thoroughly rinse any spilled battery fluid immediately.

Keep the truck clean. This will facilitate the location of loose or faulty components.

Make sure that capacity and data plates, warnings and labels are legible at all times.

Alterations or modifications by the owner or operator are not permitted without the express written authorisation from Crown.

Only use original Crown spare parts to ensure the

reliability

safety

suitability of the Crown truck.

Before Leaving the Truck

Stop the truck.

Lower the fork carriage fully.

Apply the parking brake.

Turn off the truck and remove the key.

Block all wheels when parking on an uneven surface.

Before Carrying out Work on the Truck

Raise the truck to free the drive wheel. Press the emergency Stop button and disconnect the battery.

Prevent the truck from rolling away.

Before carrying out work on the hoist frame, the lift mast or on the fork carriage:

Block these parts according to maintenance instructions in order to prevent them from dropping.

Block these parts according to maintenance instructions in order to prevent them from dropping.

Before Operating the Truck

Check the safety devices.

Get into the driver's seat.

Check the operation of :

lifting device

travel direction switch

speed control

steering

warning devices

brakes.

Warnings and Labels on the Truck

During regular maintenance check that the warnings and labels on the truck are complete and legible.

Clean any illegible labels.

Replace any faulty or missing labels.

The order and meaning of the warnings and labels on the truck are described in section 10.9 of the parts manual.