HomeIndustries Use Cases PricingResources Book a TourLog In to MaintainXIndustries Use Cases PricingResources Book a TourLog In to MaintainX Back Manufacturing / Industrial • MaintenanceCleaver Brooks Sample Cooler 750-286 MiantenanceMaintainX04/26/2021Cleaver Brooks Sample Cooler 750-286 MiantenanceDisassembly and Reassembly For heavily scaled coolers, disassembly is made easier by first dissolving the scale.Remove scale by circulating an inhibited sulfamic acid cleaning solution through the cooling water side. Replace used gaskets with new ones. After reassembly, pressurize shell and visually inspect for water leaks. Replace gaskets showing visible leaks. Keep spare shell gaskets on hand for this need. During reassembly, tighten the bolts only enough so that shell side leaking does not occur. T Series coolers require approximately 35 ft-lbs torque. F Series coolers require approximately 45 ft-lbs torque. Over-tightening can cause gasket failure.Source: Cleaver Brooks
Back Manufacturing / Industrial • MaintenanceCleaver Brooks Sample Cooler 750-286 MiantenanceMaintainX04/26/2021Cleaver Brooks Sample Cooler 750-286 MiantenanceDisassembly and Reassembly For heavily scaled coolers, disassembly is made easier by first dissolving the scale.Remove scale by circulating an inhibited sulfamic acid cleaning solution through the cooling water side. Replace used gaskets with new ones. After reassembly, pressurize shell and visually inspect for water leaks. Replace gaskets showing visible leaks. Keep spare shell gaskets on hand for this need. During reassembly, tighten the bolts only enough so that shell side leaking does not occur. T Series coolers require approximately 35 ft-lbs torque. F Series coolers require approximately 45 ft-lbs torque. Over-tightening can cause gasket failure.Source: Cleaver Brooks
