General • Inspections

Separated Combustion Indoor Gas Fired Make-Up Air Units - Seasonal Maintenance

This general maintenance procedure of your equipment is necessary for efficient operation. Follow the guidelines provided to ensure that your unit performs at its best.

MaintainX

08/06/2022

Separated Combustion Indoor Gas Fired Make-Up Air Units - Seasonal Maintenance

This general maintenance procedure of your equipment is necessary for efficient operation. Follow the guidelines provided to ensure that your unit performs at its best.

The unit should be thoroughly checked before the start and at the end of each heating and cooling season.

Motors and belts should be inspected.
Tighten belts if loose.
Check and clean DX or Chilled Water coil twice yearly, if unit is so equipped per manufacturer’s service manual. Chilled Water coil must be winterized at beginning of heating season (i.e. drain water from coil per manufacturer’s instructions).
Check air throughput at beginning of heating season to confirm unit operation is within the specified temperature rise range.
At beginning of heating season clear Condensate Drain Pan and P-trap of water if unit is equipped with DX or Chilled water coil. Clean out drain pan and fill P-trap with a non-toxic glycol solution.
Evaporative cooler must be cleaned and maintained per manufacturer’s instruction frequently during the operating season.
Inspect Control Dampers during periodic maintenance. Damper pivot points should be cleaned to ensure free damper operation.
Blower wheels should be checked periodically for dirt build-up on blades. Clean as required.

Source: MaintainX (Community Member)

The unit should be thoroughly checked before the start and at the end of each heating and cooling season.

Motors and belts should be inspected.

Tighten belts if loose.

Check and clean DX or Chilled Water coil twice yearly, if unit is so equipped per manufacturer’s service manual. Chilled Water coil must be winterized at beginning of heating season (i.e. drain water from coil per manufacturer’s instructions).

Check air throughput at beginning of heating season to confirm unit operation is within the specified temperature rise range.

At beginning of heating season clear Condensate Drain Pan and P-trap of water if unit is equipped with DX or Chilled water coil. Clean out drain pan and fill P-trap with a non-toxic glycol solution.

Evaporative cooler must be cleaned and maintained per manufacturer’s instruction frequently during the operating season.

Inspect Control Dampers during periodic maintenance. Damper pivot points should be cleaned to ensure free damper operation.

Blower wheels should be checked periodically for dirt build-up on blades. Clean as required.