Taylor Single Flavor Soft Serve Ice Cream Machine Cleaning Form

Cleaning Procedure

Pour 2 gal. (7.6 L) of cool clean water into the mix hopper. With the brushes provided, scrub the mix hopper, mix inlet hole and mix level sensing probe
With a pail beneath the door spout, raise the prime plug and press the WASH button
When a steady stream of rinse water is flowing from the prime plug opening in the bottom of the freezer door, lower the draw handle. Drain all the rinse water from the freezing cylinder, raise the draw handle and press the WASH button cancelling the WASH mode

Prepare an approved 100 PPM cleaning solution (examples: 2.5 gal. [9.5 L] of Kay-5® or 2 gal. [7.6 L] of Stera-Sheen®)
Push down the prime plug. Pour the cleaning solution into the mix hopper
While the solution is flowing into the freezing cylinder, brush clean the mix hopper, mix level sensing probe, and the mix inlet hole
Press the WASH button. This will cause the cleaning solution in the freezing cylinder to agitate
Place an empty pail beneath the door spout and raise the prime plug
When a steady stream of cleaning solution is flowing from the prime plug opening in the bottom of the freezer door, lower the draw handle. Draw off all of the solution
Once the cleaner stops flowing from the door spout, raise the draw handle and press the WASH button cancelling the Wash mode

Prepare a sink with an approved cleaning solution (examples: Kay-5® or Stera-Sheen®)
Remove the seal(s) from the drive shaft(s)
From the freezer door(s), remove: • Gasket(s) • Front bearing(s) • Pivot pin(s) • Adjustable draw handle(s) • Design cap(s) • Draw valve(s) • Prime plug(s) • All O-rings
Remove the O-rings from the air tube(s) and air orifice(s)
Return to the freezer with a small amount of cleaning solution. Brush clean the rear shell bearing(s) at the back of the freezing cylinder(s) with the black bristle brush
Remove the rear drip pan(s) and take to the sink for cleaning
Thoroughly brush clean all disassembled parts in the cleaning solution, making sure all lubricant and mix film is removed. Take particular care to brush clean the draw valve core(s) in the freezer door. Place all the cleaned parts on a clean, dry surface to air dry overnight
Wipe clean all exterior surfaces of the freezer