Konig Input Section Daily P.M.

Infeed belt: Check the transfer belts for wear and have them replaced if necessary

• Check belt for wear

• Check belt run and tension and readjust if necessary. The procedure (depending on the type of construction of the belt) is described in the subsequent pages. Info can be found on page 263 of the manual.

When adjusting the belt run/belt tension, pay attention to the following: The transfer belts must run constantly in the middle of the belt bodies. Turn the tensioning devices only in small steps of about one quarter turn each. Set the belt run: All shafts and axles must be parallel to each other to ensure that the belt runs correctly. The shafts and deflections must not run obliquely. If the belt runs off in one direction, the tensioning device in the direction towards which the belt runs off must always