Amada Band Saw Monthly PMs

Wire Brush Inspection

• Verify Wire Brush is properly applied to the saw blade and adjust if necessary.

• If the wire brush is worn, replace it.

Wire Brush Replaced?

• Yes
• No
• N / A

Slide Surfaces

• Clean slide surfaces of rust and debris.

• Apply machine oil to all slide surfaces.

Clean Chip Box

• Pull up the handle of the chip chute to remove the entire chip chute.

• Remove the chip box fixing lever, pull out the chip box, and remove it upward.

• Remove the chips from the chip box and clean the filter. Clear the filter of foreign matter with an air gun. If oil is deposited on the filter, wash it away with kerosene.

• Replace the filter in the grooves of the chip box without any clearance.

• Replace the chip box in the cutting fluid pan and apply the chip box fixing lever to the cutting fluid pan hook. Unless the fixing lever is applied to the hook, the chip box may move.

• Replace the chip chute in the cutting fluid pan.

Clean Cutting Fluid Pump Suction Filter

• Remove the cutting fluid pump and clean the suction filter.

Apply grease to:

• Driven Wheel Bearing

• Other Driven Wheel Bearing

• Worm Shaft Bearing

• Saw Blade Tension Controller Slide

• Hinge pin thrust bearing

• Rear vise stationary jaw slide (2 points)

• Movable Saw Blade Guide Slide