Oliver 702-N Bun Slicer Cleaning & Maintenance Form

The Oliver 702-N Bun Slicer Cleaning & Maintenance Form offers a simple and effective way in cleaning and maintaining the equipment. A photo is included so you can easily follow the instructions.

MaintainX

04/26/2021

Oliver 702-N Bun Slicer Cleaning & Maintenance Form

The Oliver 702-N Bun Slicer Cleaning & Maintenance Form offers a simple and effective way in cleaning and maintaining the equipment. A photo is included so you can easily follow the instructions.

NEVER ATTEMPT TO CLEAN OR SERVICE THIS MACHINE UNTIL IT HAS BEEN DISCONNECTED FROM THE POWER SUPPLY AND YOU ARE SURE THE BLADE HAS STOPPED. ALSO REMEMBER TO USE CARE WHENEVER YOU ARE WORKING NEAR THE BLADE.

Cleaning & Maintenance Procedure

Use a mild detergent solution or spray cleaner on all exterior and interior surfaces as necessary
Periodically remove the outside guide and chute guard assembly, and blade guard, then brush, or vacuum, all foreign material from below the chute and from the blade compartment.

Removing the outside guide, chute guard assembly, and blade guard

Remove the BLADE GUARD by removing the three knobs which hold it in place. Lift it clear of the machine and set it aside.
Remove the OUTSIDE GUIDE AND CHUTE GUARD ASSEMBLY by loosening both knobs which secure it in place, and then slide the assembly off the machine and set it aside.

The blade should be cleaned at least daily and may be cleaned in place.

No lubrication is required. The motor is equipped with pre-lubricated sealed bearings which require NO lubrication, DO NOT attempt to oil or grease the motor.

Source: Oliver

NEVER ATTEMPT TO CLEAN OR SERVICE THIS MACHINE UNTIL IT HAS BEEN DISCONNECTED FROM THE POWER SUPPLY AND YOU ARE SURE THE BLADE HAS STOPPED. ALSO REMEMBER TO USE CARE WHENEVER YOU ARE WORKING NEAR THE BLADE.

Cleaning & Maintenance Procedure

Use a mild detergent solution or spray cleaner on all exterior and interior surfaces as necessary

Periodically remove the outside guide and chute guard assembly, and blade guard, then brush, or vacuum, all foreign material from below the chute and from the blade compartment.

Removing the outside guide, chute guard assembly, and blade guard

Remove the BLADE GUARD by removing the three knobs which hold it in place. Lift it clear of the machine and set it aside.

Remove the OUTSIDE GUIDE AND CHUTE GUARD ASSEMBLY by loosening both knobs which secure it in place, and then slide the assembly off the machine and set it aside.

The blade should be cleaned at least daily and may be cleaned in place.

No lubrication is required. The motor is equipped with pre-lubricated sealed bearings which require NO lubrication, DO NOT attempt to oil or grease the motor.