Wells Built-In Three-Well Modular Auto-Fill Warmer Daily Cleaning Form

Preparation

• Turn control knob(s) to OFF

• Remove any insets, pans and/or adapter tops

• Drain or remove water from well if used for wet operation

Cleaning Tools

• Mild Detergent

• Solution: 10 Parts Warm Water to 4 Parts Vinegar

• Plastic Scouring Pad

• Clean Cloth or Sponge

• Food-Grade Silicone Sealant

• DO NOT use steel wool for cleaning

Cleaning Procedure

• Wipe entire unit down using a clean cloth or sponge and mild detergent

• Use a plastic scouring pad to remove any hardened food particles or mineral deposits

• Rinse warmer thoroughly with a vinegar and water solution to neutralize all detergent cleanser residue

• Inspect warmer flange-to-counter seal. Reseal with food-grade silicone sealant if necessary. Failure to do so may allow grease and water to leak into insulation and heating element, causing a potential fire and/or electric shock hazard

• Inspect warmer tank for damage. Damage to the outer body may allow grease and water to leak into insulation and heating element, causing a potential fire and/or electric shock hazard. Contact your Authorized Wells Service Agency to inspect warmer if water or grease contamination is suspected

• Close drain valve. Add proper amount of warm water. Turn control knob(s) ON and check for proper operation